á701ñDISINTEGRATION
This test is provided to determine compliance with the limits on Disintegrationstated in the individual monographs except where the label states that the tablets or capsules are intended for use as troches,or are to be chewed,or are designed as modified-release dosage forms (see Drug Release á724ñ).Determine the type of units under test from the labeling and from observation,and apply the appropriate procedure to 6or more dosage units.
For the purposes of this test,disintegration does not imply complete solution of the unit or even of its active constituent.Complete disintegration is defined as that state in which any residue of the unit,except fragments of insoluble coating or capsule shell,remaining on the screen of the test apparatus is a soft mass having no palpably firm core.
APPARATUS
The apparatus consists of a basket-rack assembly,a 1000-mL,low-form beaker,138to 155mm in height and having an inside diameter of 97to 110mm for the immersion fluid,a thermostatic arrangement for heating the fluid between 35
and 39,and a device for raising and lowering the basket in the immersion fluid at a constant frequency rate between 29and 32cycles per minute through a distance of not less than 5.3cm and not more than 5.7cm.The volume of the fluid in the vessel is such that at the highest point of the upward stroke the wire mesh remains at least 2.5cm below the surface of the fluid and descends to not less than 2.5cm from the bottom of the vessel on the downward stroke.The time required for the upward stroke is equal to the time required for the downward stroke,and the change in stroke direction is a smooth transition,rather than an abrupt reversal of motion.The basket-rack assembly moves vertically along its axis.There is no appreciable horizontal motion or movement of the axis from the vertical.
and 39,and a device for raising and lowering the basket in the immersion fluid at a constant frequency rate between 29and 32cycles per minute through a distance of not less than 5.3cm and not more than 5.7cm.The volume of the fluid in the vessel is such that at the highest point of the upward stroke the wire mesh remains at least 2.5cm below the surface of the fluid and descends to not less than 2.5cm from the bottom of the vessel on the downward stroke.The time required for the upward stroke is equal to the time required for the downward stroke,and the change in stroke direction is a smooth transition,rather than an abrupt reversal of motion.The basket-rack assembly moves vertically along its axis.There is no appreciable horizontal motion or movement of the axis from the vertical.
Basket-rack Assembly—
The basket-rack assembly consists of six open-ended transparent tubes,each 7.75±0.25cm long and having an inside diameter of 20.7to 23mm and a wall 1.0to 2.8mm thick;the tubes are held in a vertical position by two plastic plates,each 8.8to 9.2cm in diameter and 5to 7mm in thickness,with six holes,each 22to 26mm in diameter,equidistant from the center of the plate and equally spaced from one another.Attached to the under surface of the lower plate is a woven stainless steel wire cloth,which has a plain square weave with 1.8-to 2.2-mm mesh apertures and with a wire diameter of 0.63±0.03mm.The parts of the apparatus are assembled and rigidly held by means of three bolts passing through the two plastic plates.Asuitable means is provided to suspend the basket-rack assembly from the raising and lowering device using a point on its axis.
The design of the basket-rack assembly may be varied somewhat provided the specifications for the glass tubes and the screen mesh size are maintained.
Disks—
The use of disks is permitted only where specified in the monograph.If specified in the individual monograph,each tube is provided with a cylindrical disk 9.5±0.15mm thick and 20.7±0.15mm in diameter.The disk is made of a suitable,transparent plastic material having a specific gravity of between 1.18and 1.20.Five parallel 2-mm holes extend between the ends of the cylinder.One of the holes is centered on the cylindrical axis.The other holes are centered 6mm from the axis on imaginary lines perpendicular to the axis and parallel to each other.Four identical trapezoidal-shaped planes are cut into the wall of the cylinder,nearly perpendicular to the ends of the cylinder.The trapezoidal shape is symmetrical;its parallel sides coincide with the ends of the cylinder and are parallel to an imaginary line connecting the centers of two adjacent holes 6mm from the cylindrical axis.The parallel side of the trapezoid on the bottom of the cylinder has a length of 1.6mm,and its center lies at a depth of 1.8mm from the cylinder's circumference.The parallel side of the trapezoid on the top of the cylinder has a length of 9.4±0.2mm,and its center lies at a depth of 2.6±0.1mm from the cylinder's circumference.All surfaces of the disk are smooth.If the use of disks is specified in the individual monograph,add a disk to each tube,and operate the apparatus as directed under Procedure.
PROCEDURE
Uncoated Tablets—
Place 1tablet in each of the six tubes of the basket and operate the apparatus,using water maintained at 37±2as the immersion fluid unless otherwise specified in the individual monograph.At the end of the time limit specified in the monograph,lift the basket from the fluid,and observe the tablets:all of the tablets have disintegrated completely.If 1or 2tablets fail to disintegrate completely,repeat the test on 12additional tablets:not less than 16of the total of 18tablets tested disintegrate completely.
as the immersion fluid unless otherwise specified in the individual monograph.At the end of the time limit specified in the monograph,lift the basket from the fluid,and observe the tablets:all of the tablets have disintegrated completely.If 1or 2tablets fail to disintegrate completely,repeat the test on 12additional tablets:not less than 16of the total of 18tablets tested disintegrate completely.
Plain Coated Tablets—
Apply the test for Uncoated Tablets,operating the apparatus for the time specified in the individual monograph.
Delayed-Release (Enteric Coated)Tablets—
Place 1tablet in each of the six tubes of the basket and,if the tablet has a soluble external coating,immerse the basket in water at room temperature for 5minutes.Then operate the apparatus using simulated gastric fluid TSmaintained at 37±2as the immersion fluid.After 1hour of operation in simulated gastric fluid TS,lift the basket from the fluid,and observe the tablets:the tablets show no evidence of disintegration,cracking,or softening.Operate the apparatus,using simulated intestinal fluid TSmaintained at 37±2as the immersion fluid,for the time specified in the monograph.Lift the basket from the fluid,and observe the tablets:all of the tablets disintegrate completely.If 1or 2tablets fail to disintegrate completely,repeat the test on 12additional tablets:not less than 16of the total of 18tablets tested disintegrate completely.
as the immersion fluid.After 1hour of operation in simulated gastric fluid TS,lift the basket from the fluid,and observe the tablets:the tablets show no evidence of disintegration,cracking,or softening.Operate the apparatus,using simulated intestinal fluid TSmaintained at 37±2as the immersion fluid,for the time specified in the monograph.Lift the basket from the fluid,and observe the tablets:all of the tablets disintegrate completely.If 1or 2tablets fail to disintegrate completely,repeat the test on 12additional tablets:not less than 16of the total of 18tablets tested disintegrate completely.
Buccal Tablets—
Apply the test for Uncoated Tablets.After 4hours,lift the basket from the fluid,and observe the tablets:all of the tablets have disintegrated.If 1or 2tablets fail to disintegrate completely,repeat the test on 12additional tablets:not less than 16of the total of 18tablets tested disintegrate completely.
Sublingual Tablets—
Apply the test for Uncoated Tablets.Observe the tablets within the time limit specified in the individual monograph:all of the tablets have disintegrated.If 1or 2tablets fail to disintegrate completely,repeat the test on 12additional tablets:not less than 16of the total of 18tablets tested disintegrate completely.
Hard Gelatin Capsules—
Apply the test for Uncoated Tablets.Attach a removable wire cloth,which has a plain square weave with 1.8-to 2.2-mm mesh apertures and with a wire diameter of 0.60to 0.655mm,as described under Basket-Rack Assembly,to the surface of the upper plate of the basket-rack assembly.Observe the capsules within the time limit specified in the individual monograph:all of the capsules have disintegrated except for fragments from the capsule shell.If 1or 2capsules fail to disintegrate completely,repeat the test on 12additional capsules:not less than 16of the total of 18capsules tested disintegrate completely.
Soft Gelatin Capsules—
Proceed as directed under Hard Gelatin Capsules.